|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
| Tags: engine, fritz, let, play, position, setup |
|
|
Thread Tools | Display Modes |
|
#1
August 19th 03, 04:05 PM
|
|||
|
|||
Fritz 7: How to let engine play a Setup Position
On 19 Aug 2003 06:59:09 -0700, Moozie wrote:
I would like a setup position of an endgame be finished by "engine versus engine". I use Fritz 7. I can choose for "engine versus engine", but it will start a new game. Not my setup position game. Has anybody an idea on how to do this? Thanx, Moozie Maybe try Shootout, under Tools - Analysis - Shootout. John 
|
| Ads |
|
#2
August 19th 03, 11:14 PM
|
|||
|
|||
|
Fritz 7: How to let engine play a Setup Position
Ummm, are you planing to try this with only one, or two engines at the same time
(eg. Fritz 5.32 vs Fritz 7, or Fritz 7 vs Fritz 7)? Because "CeeBee" was give you the answer for the first choice, and "John Cordes" was give you the answer for the second one. Cheers... "Moozie" wrote in message om... I would like a setup position of an endgame be finished by "engine versus engine". I use Fritz 7. I can choose for "engine versus engine", but it will start a new game. Not my setup position game. Has anybody an idea on how to do this? Thanx, Moozie
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
